RPi Initial set-up

There is software for many projects. The following will be listed by category and possibly later a mindMap. Following used with a Raspberry Pi 3 B, however most links are to general information.

Initial Set-up SW and considerations for RPi 3B : 

  • Raspbian on SD card 
    • for more info RaspberryPi.org downloads to get NOOBS or Raspbian
    • updating and upgrading Raspbian
      • command: sudo apt-get update
  • Monitor
    • If display comes up blank try uncommenting: 
      • hdmi_force_unplug=1 in /boot/config.txt file. 
        • Use sudo with your favorite editor.
      • If simple doesn't work see post on Display Monitors.
    • See Which values are valid for my monitor? section for to see your current and best setting for your current display.
    • RPi 7 inch LCD touch screen
  • Recommended Power: RPi 3B 2.5A / 5.1V 
    • General rule: Helps if not powering attachments via RPi board to avoid underpower
    • Lighting Bolt:  means RPI is currently underpowered.
  • Keyboard & Mouse
    • OK: USB Keyboard & Mouse
      • powered by RPi
    • Better: wireless keyboard with touchpad
      • has own power
  • Internet: 
    • WLAN and Ethernet cable supported

Comments

Post a Comment

Popular posts from this blog

Revisiting Basics

Image
Using a Raspberry Pi 4 A blinking LED is the Hello World for physical computing.  Raspberry OS allows many ways to do this.  Here are 3 ways to Blink an LED from the RPi 4. Figure 1: Blinking LED wiring on RPi 4 (from Tutorial 3 below) (gpiozero)   Blinking LED Raspberry Pi Tutorial 1 This tutorial is great not just for blinking LED but also intro to "Physical Computing": Getting started with Breadboard. Resistor labeling code diagram included. Using a multimeter to test power provided by the RPi Understanding basic circuit first not controlled, then controlled by the RPi. Using Python from a command window, testing basics 1 line at a time. Intro to import gpiozero , a pre-installed on RPi library with import for basic needs like LEDs and buttons. from gpiozero import LED import time led = LED(17)  # GPIO17 led.on while True:      led.toggle()     time.sleep(1)      (GPIO)  Bl in king LED Raspberry Pi Tutorial 2 Alte...
Read more